Alternatively, use a communications program on both ends to start a direct connection to the other "modem" and just transfer files over some protocol, like Zmodem. You actually have two more options open to you, but their legality is, ah, well, how should I put it... It is important to observe the system's symptoms to determine in which part of the system's operation the fault occurs. Well, boys and girls, you'll have to get your hands on a real live 5.25" floppy drive to get around that. his comment is here
Cracking, for those unfamiliar with the term, is the art of removing the copy-protection routines from a program so that the program can be copied and run without the original disk. Implementation: A null-modem cable is just a serial cable with pins 2 and 3 switched and pin 7 (ground) wired straight through. I'll also discuss the issue of repairing vs. Bad drivers? Any thoughts? Thanks. Saturday, October 31, 2009 11:59 PM Reply | Quote 0 Sign in to vote Having the same problem with Win7 32 as described by Impala (internal http://www.computerhope.com/issues/ch000277.htm
Eliminating possible conflicts with other hardware If you have recently installed any new hardware, you should consider disconnecting it temporarily it to ensure that it is not the cause of your Most computers need to have the floppy setup as a 3.5, 1.44MB. Just open up the case, slide the drive in, hook up the power cable, and attach the floppy controller cable's second connection to the floppy drive. (My friend Lasse notes, however, And luckily, it's also one of the easiest failures to repair.Again, this is just a documented repair and is therefore not meant to strictly act as a tutorial.
Shane McRetro 3.334 visualizaciones 8:35 Floppy Disk Drive Disassembly - Duración: 3:41. Flag Permalink Reply This was helpful (0) Collapse - I had this problem by The Dud / September 24, 2005 2:54 AM PDT In reply to: A - Floppy Disk green In most PCs, you can use a significant event that occurs during the startup process as a key to separate hardware problems from software problems: the single beep that most PCs The Disk Media Is Not Recognized Floppy Any suggestions on what to do about this ?Thanks, Post a reply Discussion is locked Flag Permalink You are posting a reply to: A - Floppy Disk green light stays on
Symptom CheckClick on underlined items for further information Indicator light never goes on Check that the power connector is properly and securely connected. Floppy Disk Drive Problems However, with floppy drives being so cheap, head alignments are a lost art. Hope this helps. http://www.oldskool.org/guides/oldonnew/floppy Join the discussion and tell us what you think. Comments Facebook Linkedin Twitter More Email Print Reddit Delicious Digg Pinterest Stumbleupon Google Plus Powered by Livefyre Add your Comment Editor's
In my experience, the biggest consideration in deciding whether to repair or replace a drive is time. Floppy Disk Format Error in question. Welcome to the art of cracking programs. Flag Permalink Reply This was helpful (0) Collapse - Inverted signal cable.
Neat, huh? what do you mean by media to recognize? Floppy Disk Problems And Solutions Flag Permalink Reply This was helpful (0) Collapse - Don't trust the FDD connector! How To Read A Floppy Disk Without Formatting It Those ancient cards do not have TP connector at all - just AUI & BNC." Hardware needed: Network Interface Cards (NIC) on both ends, of course.
the files are saved in an older microsoft word format so it should be able to read them or so i had hoped. by CorkyMuldoon / September 23, 2005 12:13 AM PDT In reply to: A - Floppy Disk green light stays on all the time. Problem with Floppy Drive More resources Tom's Hardware Around the World Tom's Hardware Around the World Denmark Norway Finland Russia France Turkey Germany UK Italy USA Subscribe to Tom's Hardware Search http://casualobserver.net/floppy-disk/floppy-drive-problem.html Floppy drives tend to accumulate an amazing amount of dust.If after removing the dust, the drive still doesn’t want to read or write, I recommend unplugging the computer and removing the
Hope this helps. Floppy Disk Not Recognized Most of the time this is caused by plugging the floppy cable backward. You start by saying "NOT XP" - What are you saying here ?Why are you going to A: drive when your Floppy drive was assigned O:You must have had a problem
The floppy drive may need to be replaced. "Invalid media" or "Track 00 bad" error when formatting The floppy disk may be defective. Which is, unfortunately, the only thing about old software that you can't tweak or customize into shape without opening the hood. Once I reversed it, the green light only stayed on during boot (looking for a bottable floppy). Floppy Disk Driver Windows 7 Find an old 5.25" drive somehow.
Jack, I did check my connections very thoroughly and made sure they were secure and in place ...both on the floppy drive and the motherboard. The operating system side of the system does not come into play until after the beep occurs. RetroGameModz 17.062 visualizaciones 25:07 Amiga Floppy Disk Drive Repair - Duración: 10:27. check over here Transcripción La transcripción interactiva no se ha podido cargar.
howdyitsmeMar 22, 2012, 3:10 AM i mean that i don't have XP operating system i have windows 2007. To find out which component is at fault, move the data cables back to the machines they originally came out of so that each computer uses its original disk controller and Cerrar Más información View this message in English Estás viendo YouTube en Español (España). A constant green light after a motherboard change usually means the data cable isn't seated correctly.and life goes on...Jack Flag Permalink Reply This was helpful (0) Collapse - Checked my cable
Replace the floppy data cable that connects the computer floppy drive to the motherboard \ I/O board. Was this page useful? Añadir a ¿Quieres volver a verlo más tarde? Bi-directional or EPP ports help the speed.
Pls e-mail me and let me know what USB flpy drive you have: [email protected] Thanks, NH Saturday, October 09, 2010 4:36 PM Reply | Quote Microsoft is conducting an online survey are you using for your USB Floppy Drive.... In older systems floppy A: was set to ID #0 and floppy B: to ID #1. Spirantho 4.973 visualizaciones 7:14 Amiga 1200 floppy drive servicing / cleaning. - Duración: 12:10.
all your cable connections. Table 3.1 Common Configuration Error Codes After the beep tone has been produced in the startup sequence, the system shifts over to the process of booting up and begins looking for These problems are called configuration problems, or setup problems. Brian Cooley found it for you at CES 2017 in Las Vegas and the North American International Auto Show in Detroit.
If you have a drive bay free, this is perfect. The BIOS/CMOS Setup Is Your Friend I hope you were paying attention eariler in this Guide, since you're going to need your BIOS/CMOS setup skills when you install it. If the error occurs after the CMOS screen displays and before the bootup tone, you must clean boot the system and single-step through the remainder of the bootup sequence. Windows 7 IT Pro > Windows 7 Media Question 0 Sign in to vote Hi,I just set up with a new computer on win7, Unfortunately, I can not get the floppy
Now before you think I'm going to teach you cracking and get all excited, I'd like to mention two things: I'm not going to teach you how to crack software, no