Repair Floppy Disk Controller Failure (Solved) Home > Floppy Disk > Floppy Disk Controller Failure

Floppy Disk Controller Failure

Be sure to adhere to our posting rules. These drives are large and I have seen problems like cables hanging down into the mechanics of the drive and impeding its operation.If you cannot get the drive to work, the Newer PCs have the controller built into the motherboard.

Diagnosis: This is usually a problem related to the floppy disk controller, but could also be the floppy disk(s) themselves. its just won't boot. his comment is here

It can be caused by telling the BIOS that there are floppy disk drives in the system when there are not.

Recommendation: Double-check the floppy disk BIOS settings and ensure that Home - Search - Topics - Up The PC Guide ( Site Version: 2.2.0 - Version Date: April 17, 2001 Copyright 1997-2004 Charles M. In particular, it is often seen when people try to format a high-density (1.44 MB) disk as a double-density (720 KB) disk, in either a low-density or high-density drive. Please wait a moment This message may occur with identification of some outdated disks that require additional time for this procedure Hard Disk(s) Fail;

Hard Disk(s) Diagnosis Fail; Hard Disk Install

Jeff James 23.725 görüntüleme 2:49 Floppy Disk(s) Fail (40) SOLUCION - Süre: 2:02. Running Vista Home 32 bit, went into BIOS and did absolutely nothing, exited and now whenever I start, I haveFloppy disk(s) error (40)Hit F1 to continue, or F2 to enter Setupand That HDD did not like being a Master, when it was alone on the cable. Sometimes they use the same resources since they work on the floppy interface themselves.If you haven't already ruled out the floppy drive itself as a possible problem, you should try troubleshooting

And change the BIOS to the hdd, if its not set to the hdd. Bu videoyu bir oynatma listesine eklemek için oturum açın. Powered by vBulletin Version 4.2.2 Copyright © 2017 vBulletin Solutions, Inc. Jeysser Mosquera 1.847 görüntüleme 3:49 (HOW TO FIX) reboot and select proper boot device - Süre: 4:56.

If the disk controller was bad, would it still do this? It is easy with many 3.5" drives to connect the drive backwards because the cable is keyed but the connectors aren't always. If the drive's activity light comes on as soon as the PC is booted and stays on, solid the whole time the PC is on, this is a dead ringer for Save settings and exit BIOS setup.All should be fine now.Chas 0Votes Share Flag Collapse - Same problem by nualla8673 · 7 years ago In reply to No Floppy?

Part II Error Messages. Swapping the drive with another drive that works in another PC is the best way to determine if the drive or the controller are at faultI am trying to format a This occurs even with brand new disks, and even after trying several disks in a new box.Diagnosis: The usual cause of this problem is using the wrong type of media. Daha fazla göster Dil: Türkçe İçerik konumu: Türkiye Kısıtlı Mod Kapalı Geçmiş Yardım Yükleniyor...

It usually uses IRQ 6 and DMA channel 2. I hope it will help you. The A: drive is the one after the twist.Make sure that the floppy disk controller is enabled in the BIOS setup.Check the BIOS setup and make sure that the correct drive The metal piece isn't necessary for the disk to be able to be accessed, but it is mandatory for day-to-day use of the floppy disks.

Kapat Evet, kalsın. this content Junior Bracho 83.185 görüntüleme 2:18 Disk Boot Failure Fix - Süre: 3:02. You can change this preference below. I replaced the drive with a good one from another computer, with Windows ME o/s.

Kozierok.All Rights Reserved. If it is trying to boot the drive, then make sure there is a bootable disk in it.There may be a corrupted boot sector on the disk. All rights reserved. See yourhardware documentation for details, or contact yourcomputer manufacturer to get an updated BIOSI dont have any hardware documentation; my computeris a Gateway2000 P133 and is 6 years old andcontacting Gateway2000

Nik Bel 733.673 görüntüleme 4:56 Daha fazla öneri yükleniyor... All rights reserved. Try troubleshooting it here.There is an apparent failure of the floppy disk controllerExplanation: There may be a failure of some sort with the floppy disk controller.

By joining you are opting in to receive e-mail.

There are many different factors that can contribute to the failure of floppy disks, and with proper care, they can be made to last a reasonable amount of time, but they The disk may or may not actually be accessed (meaning the activity light may or may not come on) when you try the command.Diagnosis: The most common cause of this problem If you are having errors repeatedly, look in this section.If the system is not even trying to boot the floppy disk, make sure to check the BIOS setting that controls the Privacy Policy | Cookies | Ad Choice | Terms of Use | Mobile User Agreement A ZDNet site | Visit other CBS Interactive sites: Select SiteCBS CaresCBS FilmsCBS RadioCBS.comCBS InteractiveCBSNews.comCBSSports.comChowhoundClickerCNETCollege NetworkGameSpotLast.fmMaxPrepsMetacritic.comMoneywatchmySimonRadio.comSearch.comShopper.comShowtimeTech

Also, don't assume where pin 1 is on the drive, since this tends to vary with different hardware. Oturum aç Paylaş Daha fazla Bildir Videoyu bildirmeniz mi gerekiyor? And for what it's worth, there is no floppy disk in the device manager to remove. 0Votes Share Flag Back to Hardware Forum 5 total posts (Page 1 of 1)   check over here If you are having errors repeatedly, look in this section.If the system is not even trying to boot the floppy disk, make sure to check the BIOS setting that controls the

Click Here to join Tek-Tips and talk with other members! it should boot, but it just won't. 13-12-2004,10:43 AM #6 Spacemannz Guest Re: Disk Controller Failure What else is in the 98 PC??