How To Fix Floppy Drive Causing Monitor Problems? Tutorial Home > Floppy Disk > Floppy Drive Causing Monitor Problems?

Floppy Drive Causing Monitor Problems?

Contents

I have one hardrive in that I bought but is it possible to put 2 in? Screen message says "Invalid Configuration" or "CMOS Failure." PROBABLE CAUSE DIAGNOSIS SOLUTION Incorrect information entered into the configuration (setup) program. Any suggestions on what to do about this ?Thanks, Post a reply Discussion is locked Flag Permalink You are posting a reply to: A - Floppy Disk green light stays on If you are using a PS/2 keyboard and mouse, make sure you haven't connected the keyboard to the mouse port and vice versa.If the system still fails to boot, run BIOS his comment is here

Chances are the green light will go out when you reboot. Failing to recognize SATA devices may be normal behavior.If you use a standalone PCI SATA adapter card, the system will typically not recognize the connected SATA drive(s) during startup. He has coauthored numerous books, including the bestselling CompTIA Network+ Study Guide.Bibliografische InformationenTitelCompTIA A+ Complete Study Guide: Exams 220-601 / 602 / 603 / 604AutorenQuentin Docter, Emmett Dulaney, Toby SkandierVerlagJohn Wiley Bibliografische InformationenTitelFixing Windows XPJean Andrews SeriesAutorJean AndrewsAusgabeillustriertVerlagCengage Learning, 2012ISBN1418837024, 9781418837020Länge450 Seiten  Zitat exportierenBiBTeXEndNoteRefManÜber Google Books - Datenschutzerklärung - AllgemeineNutzungsbedingungen - Hinweise für Verlage - Problem melden - Hilfe - Sitemap - Google-Startseite try here

Floppy Diskette Seek Failure Dell

by squeeze / September 23, 2005 2:45 AM PDT In reply to: Don't trust the FDD connector! Check the gpu temp in the nvidia control panel (the 8800GT should be at less than 75C when idle and shouldn't get hotter than 90C under load). Most component compatibility issues are subtle.

But I think its a 650W...I can't remember the name right now. You can eliminate this possibility by temporarily connecting the front-panel reset switch cable to the power switch pins on the front panel connector block. (Both are merely momentary on switches, so If your local mains voltage is 110/115/120V, verify that the power supply voltage selector switch, if present, is not set for 220/230/240V. (If you need to move this switch, disconnect power Floppy Diskette Seek Failure Dell Optiplex Gx620 Help Report tklov87- Jan 16, 2009 at 08:29 AM I have no clue on what could fix that.

Report seema- May 1, 2011 at 05:01 PM thanks!!! Floppy Diskette Seek Failure System Battery Voltage Is Low When Windows 7 comes out and I setup a Sli video cards I'll get a new power supply. [Note: The BIOS reset got rid of my Overclock...and I didn't write down Once I reversed it, the green light only stayed on during boot (looking for a bottable floppy). After trying everything.

There were many switches and jumpers, all of which had to be set correctly or the system wouldn't boot. Floppy Diskette Seek Failure Dell Dimension E520 It took care of my "diskette drive 0 seek failure" problem. The first screen I got is the usual one except under SATA Channel listings it said Floppy disk(s) fail (40)....I don't have a floppy drive. If the system still fails to boot, replace the optical drive data cable.If the system still fails to boot, disconnect all drives except the primary hard drive and the optical drive.

Floppy Diskette Seek Failure System Battery Voltage Is Low

and I think that error message shows if these steps didn't help, go into your bios and change the settings on the drives to 1:Primary Master Drive Boot Device - CD/DVD With recent chipsets—e.g., the Intel 865 series and later—Windows XP recognizes and uses SATA drives natively. Floppy Diskette Seek Failure Dell Figure : Floppy disk controller Remove other floppy drive controllers that are listed, if any. Floppy Diskette Seek Failure Strike The F1 Key To Continue We generally leave the system with that boot sequence.

Usually BIOS tries to find a bootable drive according to its boot device order, so if a PC has a floppy drive set to a higher priority than a hard drive, this content Floppy Diskette Seek Failure, How do you fix the problem? No color on screen. Others have said it's my battery. Floppy Disk Failure Press F1 To Continue

Report jeffhei724- Jun 10, 2010 at 01:08 PM awsome had that problem and now its fixed thx Report the white knight- Jun 13, 2010 at 04:12 PM Thank you so much Password Site Map Posting Help Register Rules Today's Posts Search Site Map Home Forum Rules Members List Contact Us Community Links Pictures & Albums Members List Search Forums Show Threads The goal is to provide sufficient delay for the optical drive to spin up before the motherboard attempts to boot from it.If none of these steps solves the problem, verify that http://casualobserver.net/floppy-disk/floppy-disk-s-fail-40-error-but-i-don-t-have-a-floppy-drive.html Look for the first boot device, and make sure it's set as the hard drive.

Report Cancel- May 6, 2010 at 06:10 PM Thanks, works like a charm! Onboard Sata Hard Drive Not Present Dell Report norcal- Dec 17, 2008 at 10:58 AM Sweet tip-Worked great Report realbassplayer- Jul 12, 2009 at 09:42 PM Thanks for the great help and advice. The BIOS stands for Basic Input/output Sytem and can be found by pressing F2 after the memory test is complete and before the Windows LOGO.

Somehow the anti-virus scan mixed with downloading and a video game crash messed things up.

Emmett Dulaney, A+, MCSE, has written over 30 books on Windows, Security, IT project management, and UNIX, and is the certification columnist for Redmond Magazine and CramSession.com. Reconnect floppy cable making sure PIN1 on the Floppy Drive corresponds with PIN1 on floppy cable connector. Related Resources Floppy Diskette Seek Failure, How do you fix the problem? Alert System Battery Voltage Is Low OS install mode enabled and I have limited memory.

enter bios and switch raid-configuration on for both your harddisks (320gb each), should be working now. Be sure that pin 1 on the board corresponds to the red stripe on the cable. These settings are also listed in the motherboard manual. check over here But you might notice that where it says SIZE OF DRIVE it will say UNKNOWN.

Remove an expansion card. argggggghhhput second floppy from other comp back into other compTHE LIGHT STILL STAYED ONAre my floppys dead? Missing operating system on hard drive. Brian Cooley found it for you at CES 2017 in Las Vegas and the North American International Auto Show in Detroit.

Always check both the motherboard labels and the manual to verify configuration settings.