Repair Floppy Drive Trouble (Solved) Home > Floppy Disk > Floppy Drive Trouble

Floppy Drive Trouble


In Windows 98 and Me, click the Device Manager tab and select the View devices by type option. As to why they're called null-modem cables, I'm sure you can make an educated guess. When you are installing new hardware or software options, be aware of the possibility of configuration errors occurring. Press F10 to save and exit. his comment is here

This is due to the fact that self-booting games have to actually boot (duh) in order to run, and everyone knows that you can only boot off of drive A:. When the first screen appears, press F1 repeatedly on the keyboard to enter Setup. Floppy drives tend to accumulate an amazing amount of dust.If after removing the dust, the drive still doesn’t want to read or write, I recommend unplugging the computer and removing the When the Windows desktop appears, click Start, Programs, and Windows Explorer. check my blog

Floppy Disk Problems And Solutions

Solution: Insert a disk into the floppy drive. Solution: Reconfigure virus protection or spyware software to avoid checking the floppy drive during automatic system scans, or insert a diskette into the floppy drive and allow the software to scan Do you want to format it now? Bad drivers If you are not able to read or write to a floppy diskette from Windows, verify that the computer is not exhibiting floppy drivers issues by testing the floppy

Remove the side panel (or remove the cover). Eliminating possible conflicts with other hardware If you have recently installed any new hardware, you should consider disconnecting it temporarily it to ensure that it is not the cause of your The controllers are reloaded when the computer starts up. Floppy Disk Format Error Bad floppy disketteVerify that the floppy diskette that you are attempting to read from is not write protected or bad.

Yes, bubblegum and shoestring networking at its best. Floppy Disk Drive Problems The disadvantage is that these cables are hard to find. Cause: You are attempting to access the floppy drive but have not inserted a diskette in the floppy drive. Because of the technology of floppy diskette drives, it is likely for a floppy diskettes to become bad.

It's unbelieveable. Floppy Disk Driver Windows 7 If they are, you’ll need to replace the disk controller.Most often, this requires replacing the system board. Those Paranoid Software Companies Those silly programmers! It's a half-height unit that contains both a 3.5" drive and a 5.25" drive.

Floppy Disk Drive Problems

The system's configuration settings are normally checked first. Just make sure to let the heads dry completely before plugging the drive back in.ConclusionIt’s often cheaper to replace a floppy drive than to repair it. Floppy Disk Problems And Solutions Once you enter the setup, go to the section where it lists the attached floppy drives, and switch the entry for the second "B:" drive from "None" or "Not Installed" to How To Read A Floppy Disk Without Formatting It If the floppy drive is not setup properly you may experience read/write errors or the floppy may not work at all.

It may be possible to recover the disk: Turn off the PC and unplug the power cord. I have one of these things and it has really come in handy in a cramped case that I had to transfer old files on. If you don’t hear the disk spinning when you attempt to access the drive, but the drive’s light comes on, you can be relatively sure you have a motor problem. If you have this type of problem, it's game over: Go buy a new drive.Motor problemsIt’s easy to tell when you have a motor problem. The Disk Media Is Not Recognized Floppy

If you do not have a tab place tape over this hole. Obtaining a floppy drive is easier than you think. If the disk is not write protected try another floppy disk. Verify that other floppy diskettes are not exhibiting the same issue.

If other floppies work it is likely that you may have a bad floppy diskette. Floppy Disk Not Recognized If you cannot confirm a configuration problem, you most likely have a defective component. You sometimes can't believe the diverse number of tricks and flaws that copy protection exploits to fool diskcopy programs.

If the floppy disk is not write-protected and still cannot be written to, try another disk.

Was this page useful? Contact HP Support for assistance. HP and Compaq Desktop PCs - Floppy Drive Troubleshooting Troubleshooting the floppy drive Error message: The disk may be write protected Floppy disk is stuck in drive Clicking noise coming from Symptoms Of Floppy Disk Failure However, some readers are probably raising their hands right about now and asking, "But Jim, what if the software is copy-protected?" Well, astute readers, you have a point.

End task all running TSRs and background programs. If the system produces an error message (such as "The system has detected unstable RAM at location x") or a beep code before the single beep occurs, the system has found Work on a hard flat surface over a non-carpeted floor. check over here Even though floppy drives cost less than 20 dollars these days, they're still complex pieces of equipment.

Replace the following hardware in the computer in the below order. Replace the following hardware in the computer in the below order. If connected, disconnect, and then connect the floppy drive cable to verify seated properly. The metal slide cover has probably become bent and is hitting on the inside of the drive.

Now before you freak out, don't get all upset because you don't have any free drive bays or don't like to open the hood or something. This document helps resolve floppy drive failures and errors. I thought you'd never ask: Type: Null-Modem ("Serial") Cable Where you can get it: Build one, or visit any "complete" computer store, like Micro Center, etc. If your floppy cable has more than one connection, verify that you have connected the floppy to the appropriate connection.

But what kind of cable? Problem with Floppy Drive More resources Tom's Hardware Around the World Tom's Hardware Around the World Denmark Norway Finland Russia France Turkey Germany UK Italy USA Subscribe to Tom's Hardware Search When it becomes necessary to replace the CMOS backup battery on the system board. Be careful to not dislodge the other ribbon cables.

If the configuration settings are correct, but these symptoms are present, a hardware problem is indicated as the cause of the problem. Z7_3054ICK0KGTE30AQO5O3KA30H5 hp-country-locator-portlet Actions ${title} Loading... Other components may also cause these same symptoms, check the general diagnosis page for more information. Indicator light never goes off The interface cable may be reversed.

Click Yes or OK to confirm removal. To reduce the chance of ESD damage, work over a noncarpeted floor, use a static dissipative work surface (such as a conductive foam pad), and wear an ESD wrist strap connected This is good news, because these are the only serviceable components in the drive.Most of the time when a read/write head has problems, it’s either dirty or out of alignment. Replace the floppy if the floppy data cable did not resolve your issues.